556hw on 1999 honda accord

so i am putting an autopage remote start with DEI 556hw bypass module on a 99 accord and I am having trouble with the module. after I program the module it says to turn off key then turn it back on to confirm its programmed, once i do that the l.e.d. light does not come back on confirming this. can someone please provide me with what color wires need to be hooked up to just so I can make sure I have it wired right. if i leave the key in the ignition it starts. any help will be greatly appreciated

Are you using the black key to program the bypass?Installer, IT support, and FFL. I need less hobbies.

yes, it goes to the part where it blinks twice but once i turn key off and then back on to confirm there is nothing.

nobody has any info?? maybe someone knows the exact wires to connect to because the install directions for this module are very vague. any help will be huge

i dont think the modual can confirm that its programmed. Just remote start it and see if it works, if it does then its programmed correctly.

did you try remote starting the vehicle, despite the lack of LED confirmation of programming?The search function is your friend.

tedmond wrote: i dont think the modual can confirm that its programmed. Just remote start it and see if it works, if it does then its programmed correctly.

i could post word for word what the install manal says but it does say that it will confirm that it is programmed. i am absolutely baffled, cuz like i said the directions for what wires are to be connected on the car side is basically worthless.

peterubers wrote: did you try remote starting the vehicle, despite the lack of LED confirmation of programming?

yes i did. it just cranks. but if i have the key in the ignition it will start

got the  manual? if soi can show u which wires u use and which is on the car.99 accords should have 5 wires in a green plug. im not sure what wires come ofwf the unit but on the car it lists as

Pin 1 - Yellow/Black (Ignition)

Pin 2 - Red (Data)Pin 3 - Blue (Data Synchro)Pin 4 - BROWN / Black (Ground)Pin 5 - N/C  

alright found the manual and this is how u should connect it

556HW

make sure ur in mode 2 by entering program mode and with the button, press untill the unit flashes 2 times. once it flashes 2 times, its ready.

RED- 12v constant

BLACK (556hw)  to Pin 4 - BROWN / Black (Ground)PINK (556hw) to Pin 1 - Yellow/Black (Ignition)ORANGE / BLACK (556hw) to Pin 3 - Blue (Data Synchro)CUT RED wire on 5 pin Harness (green plug) Yellow/Black (556hw) to Pin 2 - Red (Data)towards key cylinder or plugYellow (556hw) to Pin 2 - Red (Data) towards Car ECM or to the front of ur car.Blue/White - ground in from remote start or connect to wire that says GROUND OUT WHEN RUNNING