08 outlander key sence

Well im having a nightmare with the keysence on this vehicle. Ive installed everything correct. All the tech data says RED / white open circuit. Now the wire tests neutral. As soon as i put my test light on the wire everything activates and it unlocks the sterring, when i cut the wire the vehicle starts, but i cant get it to do this when i put a ground, current, and resistor with either polarity the vehicle wont start..

Very odd vehicle, im really in a bind, help asap THANKS!

u tried to use a relay?      pin 87a to key side of keysence, pin 30 to car side of keysense  pin 85 to ground when running from starter, and pin 86 to 12volts.

should open the wire w/ remote start is activated.

On the 2008 the keysense is a Light/Blue negative wire, if the vehicle fail to remote start when you trigger this wire using a (-) signal it's because the vehicle is attempting to knowledge the transponder when the keysense comes ON. If your transponder module is not ready to chanllenge the immobilizer, your remote start sequence will fail. the vehicle will still challenge the transponder upon ignition but chances to fail are drastically increasing.