power window problem

I,m remaking the interior of an 25 year old pontiac fiero. I can´t figure out how to remake my new buttons for the power window. What i need is a diagra of how to connect the realys for: two buttons per motor. One button for up, and one button for down in the car per side : 4 cables 1 is + 1 is - 2 cables for the engine Can sombody help my understand and maybe dra a diagram for me?

Look in the relay section on this site, look for "adding actuators". It's exactly the same circuit. All these motors have 2 motor wires. In 99% of vehicles exc. some Mercedes and Mk II Golf/Rabbit, both sit on ground at rest (i.e. off) then one goes 12V+ while the other stays at ground to go one way, vice versa for the other way.

Come to think of it, you could substitute a DEI 530t for the relays and give yourself a one-shot up and down system.

Ignore my last reply, please describe your window switch, how many terminals?

take a breath howie.....yuk

quiet rural missouri, near KC.

If your system moves you physically and not emotionally, you have wasted your money.

Sorry for my bad english... but the connector in the car has 4 cables( 1 is +, 1 is ground and 2 that goes to the power window motor) and the original switch (taken apart)har 4 on the bottom and 6 on top. all i need is to connect 2 new buttons per window, one button for up, and one button for down. when i connect two cabbles on the original connector (one from + to one off the motor cable and the ground to the other motor cabel) the window goes up. but when i switch these cables the window goes down. the new button are simle push buttons. Plz help draw a working diagram on how to connect the relays. i think i need one relay per button.

i googled fiero window switches and found a guys post on doing what i think you are trying to do.

here is the link to his post...

http://www.chalnet.net/Fiero/Fiero%20Power%20Window%20Switch%20Upgrade.doc

yuk

quiet rural missouri, near KC.

If your system moves you physically and not emotionally, you have wasted your money.

First off...thanks for youre quick replyes. I saw that one too, but thats not what i need. this is what i whant: http://www.fiero.nl/forum/Archives/Archive-000001/HTML/20060206-2-062039.html but with diffrent buttons and no one-push-down somthing like this:http://www.fiero.nl/forum/Forum3/HTML/000035-5.html but i need a diagram i´m not an electrician i´m plumber haha plz plz plz plz plz it´s driving my crazy

Sorry itsyuk but the language barrier, Arabic to Swedish to English is confusing me. The original switches will work fine, DPCO momentary, without a relay. Nazim what are you trying to achieve, one shot? Direct replacement?

Yes...almost.The panel is ready with holes for the buttons and all. All i want is to connect the buttons.