Turn Signal Clicking

Home / the12volt's Install Bay / Relays / Turn Signal Clicking (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

sbauld

Member - Posts: 2

Joined: September 06, 2006

Posted: September 30, 2006 at 10:54 AM / IP Logged

I have installed the Avic Z1 Nav in a 2007 Tahoe. With the install of the GMOS-LAN-01 I was able to retain factory chimes ect. However the LAN01 instructions say that to retain turn signal clicking I would need to add an SPDT relay to the set up. I followed the following instructions.

1. Connect Pin 85 to the BLACK/ white wire of the 12 pin harness (lan01)

2. Connect Pin 86 to the 12 volt constant of the 12 pin harness (lan01)

3. Cover All other leads.

So far the only thing that I get is a clicking when the chimes turn on. I would appreciate if anyone has some advice on this. Thanks in advance for the help!

bellsracer

Silver - Posts: 703

Joined: January 14, 2006

Location: United States

Posted: October 01, 2006 at 2:23 PM / IP Logged

Well that is what it is supposed to do, give you a click when the turn signals turn on and off. What effect were you looking for? Is it causing any trouble for you anywhere else?

Never send your ducks to eagle school.

The difference between ordinary and extraordinary is that little extra.

The 3Ls of life: Learn from the Past, Live for the Present, Look to the Future.

hotwaterwizard

Silver - Posts: 1,350

Joined: December 11, 2003

Location: California, United States

Posted: October 03, 2006 at 12:49 AM / IP Logged

I just did the same thing on my 64 VW Bug

I hooked the Relay to the Flasher and Ground.

John DeRosa (Hotwaterwizard)

Stockton California

When in doubt, try it out !

Search for other posts by hotwaterwizard

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Turn Signal Clicking

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.