2012 toyota sienna data imo , imi?

I just wired up a viper car starter and am stuck on finding the data IMO and data IMI wires. Ive read to the left of the steering column it is the green and purple but cannot find them there. Does anybody know where these wires are? I have a LE AWD V6 without the smart key and I'm wiring in an express kit XK05. Thanks

This should help  :   http://www.checkyourground.com/Soldering is fun!

Can't get a better view then that! Thank you!!

A picture is worth a thousand words...  Soldering is fun!

Just wired it up this morning. Very easy to find those wires after seeing that websites picture. Thanks again kreg357!!

Can you send me link to the wiring diagram thanks

Here is a link to the wiring info from ReadyRemopte :  http://www.readyremote.com/main.asp?make=Toyota&model=SiennaSoldering is fun!

I started installing my compustar in my sienna. For the accessory wire I found the blue wiring at the ignition connector but it is on PIN number 2. The instructions indicate that the blue wire should be PIN number 3 which is white. Anybody have some suggestions. How can I test this I don't want to fry anything.

Use a DMM.

I do have a voltage meter. Do you know what I should be looking for if it will be 0v without key, 12v in accessory, 0v when starting, and 12v when ignition in the on position. I would also be interested in knowing what the other wires are in the ignition switch are as there is a total of six wires and I'm using or wiring just three. Wish I had the dealer wiring diagram so I could be totally sure. I'm still beginner but trying. Anybody know what would happen if I don't wire the accessory? I'm hoping its not needed but want to make sure I have heat going through accessory blower.