2012 Honda Civic Coupe Alarm/Remote Start Wiring

Trying to get the correct wiring to install a compustar cs800-s on a 2012 Honda Civic coupeKeith Andrew Stone

CIVIC      2012-2015 KEY      T-HARNESS      IMMOBILIZER N/A      N/A      Equipped with Honda's TRANSPONDER Anti-Theft System, SEE NOTE #1 PART      COLOR      LOCATION      DIAGRAM 12 VOLT CONSTANT      WHITE (+)      @ IGNITION SWITCH, WHITE 6-PIN PLUG, PIN 1       STARTER      YELLOW (+)      @ IGNITION SWITCH, WHITE 5-PIN PLUG, PIN 5       STARTER 2      N/A            IGNITION 1      BLUE (+)      @ IGNITION SWITCH, WHITE 5-PIN PLUG, PIN 2       IGNITION 2      N/A            IGNITION 3      N/A            ACCESSORY/HEATER BLOWER 1      ORANGE (+)      @ IGNITION SWITCH, WHITE 5-PIN PLUG, PIN 4       ACCESSORY/HEATER BLOWER 2      RED (+)      @ IGNITION SWITCH, WHITE 6-PIN PLUG, PIN 3       KEYSENSE      N/A            PARKING LIGHTS ( - )      GRAY (-)      @ HEADLIGHT SWITCH, 12-PIN PLUG, PIN 8       PARKING LIGHTS ( + )      RED (+)      @ DASH FUSE BOX, GREEN 44-PIN PLUG(B), PIN 29       POWER LOCK      BLUE (-) TYPE B      IN DRIVERS KICK @ DOOR HARNESS, 25-PIN PLUG, PIN 11       POWER UNLOCK      GRAY (-) TYPE B      IN DRIVERS KICK @ DOOR HARNESS, 25-PIN PLUG, PIN 18       LOCK MOTOR WIRE      N/A            DOOR TRIGGER      GREEN (-)      @ DASH FUSE BOX, GREEN 44-PIN PLUG(B), PIN 39       DOMELIGHT SUPERVISION      PINK (-)      BELOW DASH FUSE BOX, 28-PIN PLUG, PIN 18       TRUNK RELEASE      N/A            SLIDING POWER DOOR      N/A            HORN      ORANGE (-) or PINK (-)      @ HORN SWITCH       TACH      YELLOW, BLUE, RED, BROWN (AC), TAN, BLUE, RED, PURPLE (Si MODELS)      @ ANY FUEL INJECTOR, 2-PIN PLUG, PIN 1       WAIT TO START LIGHT      N/A            BRAKE      LT. GREEN (+)      @ BRAKE SWITCH or DASH FUSE BOX, 44-PIN PLUG (B), PIN 10       FACTORY ALARM DISARM      BROWN (-) (TEST WITH DRIVERS DOOR KEY)      IN DRIVERS KICK @ DOOR HARNESS, 25-PIN PLUG, PIN 9       ANTI-THEFT      TRANSPONDER ANTI-THEFT SYSTEM            NOTES NOTE #1: This vehicle is equipped with HONDA'S TRANSPONDER ANTI-THEFT SYSTEM, you have (3) options to bypass the Anti-Theft system on this vehicle, option 1 requires an extra IGNITION KEY that starts the vehicle to be placed INSIDE the 791 Bypass Module OR inside the B-Series Remote Starters WITH Built in bypass, this key must remain inside the bypass for Remote starting. Option 2 is, IF you have (2) keys that start the vehicle, you can use Part # PKALL, this INTERFACE BYPASS MODULE requires (2) keys that start the vehicle for programming, but you will NOT have to place a key inside this module. Option 3 is using the DBALL2 INTERFACE BYPASS MODULE, this module requires only 1 Key for programming and makes the installation of the remote starter a little easier, all connections such as, door lock and unlock, the trunk release and brake connections are all made at the Interface bypass module, you do not have to locate and connect these wires in the vehicle.~wirewise~ Verify all wiring with your meter before making any connections!