04 Monte Carlo Door Trigger

Home / the12volt's Install Bay / Vehicle Wiring Information & File Requests / 04 Monte Carlo Door Trigger (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

d4productions

Member - Posts: 5

Joined: February 03, 2004

Location: United States

Posted: March 04, 2005 at 7:23 PM / IP Logged

I installed an alarm on my 2004 Monte Carlo, and I'm having a hard time finding a door trigger. I tried to use the light under the dash the White wire, but after the alarm is armed for 10 minutes the alarm will go off.

mobileworks

Copper - Posts: 136

Joined: December 16, 2004

Location: United States

Posted: March 04, 2005 at 9:53 PM / IP Logged

try putting a diode or relay to active your door trigger wire. Tech data says that its seperate door trigger wires at the BCM and that you should diode isolate to prevent falsing. Perhaps this is like the Ford Trucks where the BCM sends pulses on the wires every once in a while and causes the alarm to false.

I would try to wire a relay to the under dash light and then send the output of the relay to the alarm.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

04 Monte Carlo Door Trigger

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.