2005 Focus Alarm/Remote Start

Looking for wiring information for a 2005 Ford Focus.

12 VOLT CONSTANT   RED (+)    IGNITION SWITCH HARNESS      STARTER GRAY/BLACK (+)   IGNITION SWITCH HARNESS      STARTER 2 N/A       IGNITION 1 GREEN/ YELLOW (+) IGNITION SWITCH HARNESS    IGNITION 2 N/A        IGNITION 3 N/A        ACCESSORY /HEATER BLOWER 1 YELLOW (+)   IGNITION SWITCH HARNESS      ACCESSORY /HEATER BLOWER 2 N/A        KEYSENSE RED / BLACK (-)   IGNITION SWITCH HARNESS      PARKING LIGHTS ( - ) N/A        PARKING LIGHTS ( + ) ORANGE / YELLOW (+)   @ HEADLIGHT SWITCH or GEM, TAN Plug, Pin 14, See NOTE *4      POWER LOCK BLACK/ RED (TYPE B)   IN DRIVERS KICK PANEL or GEM, GRAY Plug, Pin 15, See NOTE *4      POWER UNLOCK BLACK / YELLOW (TYPE B)   IN DRIVERS KICK PANEL or GRAY Plug, Pin 21, See NOTE *4      LOCK MOTOR WIRE YELLOW/BLACK (+)   IN DRIVERS KICK PANEL      DOOR TRIGGER See NOTE *1   @ GEM, See NOTE *4   29358_FOCUS_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf DOMELIGHT SUPERVISION BLACK/ BLUE (-)   @ GEM, GREY Plug, Pin 3, See NOTE *4      TRUNK RELEASE BLACK / YELLOW (-)   @ TRUNK RELEASE SWITCH      SLIDING POWER DOOR N/A        HORN BLACK/ BLUE (-) or BLACK/ GREEN (-)   @ STEERING COLUMN HARNESS or GEM, BROWN Plug, Pin 14      TACH BLACK/ GREEN or BLACK/ ORANGE   @ IGNITON COIL      WAIT TO START LIGHT N/A        BRAKE GREEN/ RED (+)   @ GEM, TAN Plug, Pin 9, See NOTE *4      FACTORY ALARM DISARM   BLACK/ WHITE (-)   @ GEM, GRAY Plug, Pin 14, See NOTE *4      ANTI-THEFT FORD'S SECURILOCK ANTI-THEFT TRANSPONDER SYSTEM   TRANSPONDER @ IGNITION SWITCH TUMBLER      NOTES NOTE *1 This vehicle has (4) door trigger wires, the DRIVERS DOOR is a YELLOW/BLACK (-) in a TAN Plug, Pin 22, the PASSENGER DOOR is a BLACK/ BLUE (-) TAN Plug, Pin 21, the DRIVERS REAR DOOR is a BLACK/ ORANGE (-) in a WHITE Plug, Pin 15 and the PASSENGER REAR DOOR is a BLACK/ GREEN (-) in a GRAY Plug, Pin 15. When connecting to an ALARM SYSTEM use all 4 DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE *2 The IGNITION SWITCH MUST be turned on before the Brake wire will test properly. NOTE *3 The FACTORY KEYLESS ENTRY Module (if so equipped) is located behind and to the right of the GLOVE BOX. NOTE *4 The GEM (Generic Electronic Module) is located above the PASSENGER KICK PANEL.