Door Locks on 95 Grand am

POWER LOCK|lt. blue            | +  |         gray conn R of e-brake *3   |

Also found at door lock relays, drivers underdash left of steering column. This is a (+) type B system

So I can hook up the outputs from my keyless module to these wires without relays. I am using a dei 710t

The 710T states that you do not need relays for this as they have internal relays that alternate polarity. Atach the GREEN wire from H2 --------->WHITE wire on GA and the BLUE wire from H2 --------------> LIGHT BLUE wire on the GA. If nothing happens when you do this ( the door locks do not actuate ) then you will need relays because the (+) current may not be enough to trigger the Pontiac's locking circuit. If this is the case use the above wires from the H2 and hook it up to 2 relays like it says in the POSITIVE INPUT-----------> POSITIVE OUTPUT diagram in the link below:

http://www.velocitymotorsport.com/install_notes/Converting_Outputs.jpg