ProStart CT-3300

I have installed remote keyless entry and remote start on my 1994 GMC Suburban but I can't figure out how to wire in the remote door locks.  I don't have a wiring diagram and the instructions are not helping.   It says the brown wire is the (-)500mA lock output and the green wire is the (-)500mA unlock output, where would I connect these wires on my vehicle.  I would apprecaite any advice.  Thank You

       POWER LOCK|lt. blue            |+  |either door boot            |

|     POWER UNLOCK|BLACK/ red           |+  |either door boot  

You will need spdt relays.  

85-brown wire from alarm

86-constant 12V

87-constant 12V

30-out to lt. blue wire in car

87A-not used

----------------------------------------------

85-green wire from alarm

86-constant 12V

87-constant 12V

30-out to BLACK/ red in car

87A-not used

Thanks Jason this worked perfectly.  Thank You