2003 Land Rover Freelander

12volts  brown (60A), BROWN / red (60A)   +   ignition harness 

Starter  WHITE/ red   +   ignition harness          Ignition  green   +   ignition harness  Second Ignition  BROWN / white   +   ignition harness          Accessory  gray/blue   +   ignition harness  Second Accessory  PURPLE / gray   +   ignition harness           

Power Lock  BLACK/ brown   -   CCU, 26 pin plug, pin 20  

Power Unlock  BLACK/ pink   -   CCU, 26 pin plug, pin 8   Lock Motor  pink   5wi  CCU, 10 pin plug, pin 4   Unlock Motor  orange   5wi  CCU, 10 pin plug, pin 7  

Parking Lights+  red or RED / white   +   headlight switch         

Hazards  same as turn signal wires        Turn Signal(L)  GREEN/ red   +   turn signal switch  Turn Signal(R)  GREEN / WHITE   +   turn signal switch  Reverse Light  GREEN/ brown   +   CCU, 26 pin plug, pin 4  Door Trigger  pur/gray (D), pur/wht (P)   -   CCU, 26 pin plug, pins 24 and 21  Notes: Use both wires and diode isolate each.. Dome Supervision  use door trigger wire        Trunk/Hatch Pin  BLACK/ orange   -   CCU, 26 pin plug, pin 23  Hood Pin  RED / purple   -   CCU, 26 pin plug, pin 22  Trunk/Hatch Release  ORANGE / brown   -   CCU, 26 pin plug, pin 18  .      

Factory Alarm Arm  BLACK/ pink   -   CCU, 26 pin plug, pin 19 

Factory Alarm Disarm  BLACK/ red   -   CCU, 26 pin plug, pin 7            

Tachometer  NOT BROWN / pink or black   ac   any ignition coil        

Brake Wire  GREEN/ purple or GREEN/ pink   +   brake pedal switch  Parking Brake  BLACK/ white   -   parking brake switch  Horn Trigger  purple / YELLOW   -   CCU, 10 pin plug, pin 5 

Notes: The CCU (Central Control Unit) is attached to the back of the fuse box under the driver side dash.         

I

Immobilizer Bypass Required

Type:Transponder

Hope that helped..remember to verify all wires with a DMM before connecting as no one is responsible for the installation but you and mistakes/changes happen.