2000 mazda 626 v6 factory alarm

Home / the12volt's Install Bay / Vehicle Wiring Information & File Requests / 2000 mazda 626 v6 factory alarm (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

negrosourous

Member - Posts: 1

Joined: February 28, 2007

Location: United States

Posted: February 28, 2007 at 9:04 PM / IP Logged

I recently installed a remote start in a mazda 626 v6 and i could not intergrade the factory alarm with the after market remote start the disarm wire had no effect when i put a possitive signal to it if ,anyone knows of an other way i would appreciate it

jv

Back to Top

master5

Silver - Posts: 1,123

Joined: October 10, 2006

Location: United States

Posted: March 01, 2007 at 6:43 PM / IP Logged

To disarm without unlocking, send a positive trigger to the blue / YELLOW key sense wire. The key sense wire is located at the steering column. If this is the way you already attempted it you either have a poor connection...the wrong blue / YELLOW (the keysense wire you should be able to follow it right to the cylinder) or you are not sending a positive (check with a DMM).

Hope I was of some help..good luck.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

2000 mazda 626 v6 factory alarm

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.