remote start / stop, 99 lexus rx300

Thanks Joe, for some reason i didnt think the ign 2 wire was needed and i dont know why i thought that. remote start works now. Any help with the door locks? unfortunately, this car has a door ECU in each door. I would like to have drivers priority set for the locks. ps..... i need your paypal address and i will send you $20 for lunch.

Glad you got it working. I appreciate the offer but that's what this forum is for. As far as the locks I will need to wait till I get home check my notes. I haven't been inside a rx300 in 10 years. If I remember right you will need at least 1 relay and diodes to interface with the locks. Then adding drivers door priority you will need a relay to control just the drivers door lock actuator. I won't be home till later on this evening out doing mobile installs. Typing this from my phoneIf i Can't Install it    I Don't need it   Joe

chev104275 wrote: Glad you got it working. I appreciate the offer but that's what this forum is for. As far as the locks I will need to wait till I get home check my notes. I haven't been inside a rx300 in 10 years. If I remember right you will need at least 1 relay and diodes to interface with the locks. Then adding drivers door priority you will need a relay to control just the drivers door lock actuator. I won't be home till later on this evening out doing mobile installs. Typing this from my phone

Thank you very much. I will wait for your info. Please be detailed as you know im not real sharp. lol...thanks again!

ok for the locks you have the diagram you need on page 4 of this post. You will need to run wires through the door jam into the door. To test these wires don't use the rocker switch on the door test them by turning the key in the drivers door. You will also need a relay and some diodes (something like 1N4001 will work fine for this application). If I remember correctly there is a thick Constant power at the window switch you can use for pin 85 of your relay just remember to fuse it between the relay and the power wire. once you have the locks working correctly we can move on to the driver door priority portion. For drivers door priority you will need another relay and will need to 5 wire the motor wire. I've never done drivers door priority on one of these trucks and none of my diagrams list the motor wires so you will need to test to figure out what is what there.   Good LuckIf i Can't Install it    I Don't need it   Joe

Ok I will give it a go after i order the parts. Thanks

Constant power to pin 85 Joe The OP's previously posted wiring diagrams give us the required posters, OP needs to test.

Ha ha yea I said 85 because it was the one used in the diagram didn't want to cause anymore confusion. Yea he needs to do some leg workIf i Can't Install it    I Don't need it   Joe

What are you guys saying?

What relay do i need? You said PN 1N4001 for the diodes.

Standard Bosch type automotive type relay 5 or 4 pin will work for this application. I don't have a part number handy for those.If i Can't Install it    I Don't need it   Joe