Intellistart 4 RPM Programming

Home / the12volt's Install Bay / Car Security and Convenience / Intellistart 4 RPM Programming

Welcome Guest :)

Members

Search

Register

Login

< Prev Page < Prev Topic Next Topic >

howie ll

Pot Metal - Posts: 16,466

Joined: January 09, 2007

Location: United Kingdom

Posted: January 07, 2016 at 1:56 PM / IP Logged

Sorry about that now I know why I retired!

Back to Top

punker

Member - Posts: 10

Joined: January 07, 2016

Location: United Kingdom

Posted: January 08, 2016 at 12:09 PM / IP Logged

Hey Howie, OK so I picked up the bits today from Hayes and managed to program the RPM manually :) Well I guess I did, because the remote start does actually work, although the engine dies after 5 ish seconds, and does that 3 times.

Any idea what that's all about?

Back to Top

howie ll

Pot Metal - Posts: 16,466

Joined: January 09, 2007

Location: United Kingdom

Posted: January 08, 2016 at 12:28 PM / IP Logged

It would run 15 seconds if tach wasn't recognised, have you got all the ignition loom wired up?

Set up as a diesel with glow-plug delay?

Back to Top

punker

Member - Posts: 10

Joined: January 07, 2016

Location: United Kingdom

Posted: January 08, 2016 at 2:51 PM / IP Logged

Ah OK. Well now it seems a bit hit and miss. Most of the time it starts fine. But then other times, it will start up twice, but then cut out after 4-5 seconds. Then on the third try, it starts up and stays on.

I've check the ignition, starter and accessory wires and the all seem OK.

I have noticed that it doesn't wait for the glow plug to go out, even though I have it wired up? I'm pretty sure I read to leave the fuel type as 'gas' and wire up either a glow plug (+) or glow plug (-) and it will wait to stop seeing that before cranking. Have I got that right?

Thanks :)

Back to Top

howie ll

Pot Metal - Posts: 16,466

Joined: January 09, 2007

Location: United Kingdom

Posted: January 08, 2016 at 2:56 PM / IP Logged

No, leave it as diesel, use the whiz to set up the wait to start, say 4 seconds then after using whiz reprogram tach.

Back to Top

< Prev Page

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.