Honda window wiring diagram

http://www.icelord.net/honda/repair/Wiring%20diagrams.pdf

It's on page 18.

I'm trying to plan out which wires to cut for dei 530t window module. I'm going to use only the driver side master window switches to control both the drivers window and the passenger window..

1. From the diagram(section A), for the passenger window switch on the master switch, blu/yel for up and blu/blk for down are connected to the passenger switch on the passenger side. The wires for the passenger window motor is connected to the passenger switch side.

My question is where should I cut the wires for the motor.? Should it be between the master switch and the passenger switch? Or should it be between the passenger switch and the motor? 

2. Also from the diagram(section B), I'm confused about the driver side part of the master switch. Notice that there is only one wire for up and down for the switch(wht/blk). Should I just wire the up and down wires from the module to that single wire?

3. Lastly, The drivers window already has auto down. Should I wire the module to auto down part of the switch or the down part of the switch///?

thanks

|  LF WINDOW UP/DN|RED / yel, RED / blue   |A  |driver's door switch        |

Grab the wires from the driver side switch. This is the master switch for both windows. Use the wires above and this will make the windows ( both ) go auto down with a module.

Is that right? - the color codes are switched for up and down in the car database.  Below is a diagram from the helms manual

I'm trying to wire another window module for the passenger side. However - it does not work. I would not be able to cut in half the blu/wht and the blue red wire since there isnt a motor side of for the wire. The motor side of the wire is blu/red and blu/wht.

I tried wiring it just using the blu/wht and the blu/red but it would not work. Any ideas?