2000 Pontiac Grand Am Cruise Control Wiring

Home / the12volt's Install Bay / Vehicle Wiring / View all Pontiac Vehicles / 2000 Pontiac Grand Am

Vehicle Search	Manufacturer
Select Vehicle Manufacturer
If you do not find the vehicle information you're looking for here, please post your request here. We will NOT respond to any requests by email.

• Alarm Information

• Stereo Information

• View all Pontiac Vehicles

Please do not copy and paste this table into your forum posts. Please copy and paste the link below instead:
( 2000 Pontiac Grand Am Cruise Control Information )

2000 Pontiac Grand Am Cruise Control Wiring Information
Constant 12V+	Red (2)	Ignition Switch Harness, Remove Radio or Instrument Cluster or Use Hot Side of Brake
Switched 12V+	Pink	Ignition Switch Harness, Remove Radio or Instrument Cluster
Ground	Use Chassis	Near Cruise Control Module
Hot Side of Brake	n/a	Brake Switch
Cold Side of Brake	Light Blue	Brake Switch
Tach	Purple/White or White	Coil
VSS Wire	Yellow	Left of Steering Column Connector under Dash PCM
Pulses Per Mile	4000 PPM
Notes: Vehicles with Manual Transmission require Clutch Switch. Some vehicles may require a speed signal generator and/or other parts/adapters not listed above. Rostra® Cruise Control module switch settings may differ if you use a speed signal generator or magnets and a pick up coil.

• Alarm Information

• Stereo Information

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.