the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

1996 Chrysler Sebring Convertible Cruise Control Wiring

Vehicle Search Manufacturer
Select Vehicle Manufacturer
If you do not find the vehicle information you're looking for here, please post your request here. We will NOT respond to any requests by email.

Please do not copy and paste this table into your forum posts. Please copy and paste the link below instead:
(
1996 Chrysler Sebring Convertible Cruise Control Information )

1996 Chrysler Sebring Convertible Cruise Control Wiring Information
Constant 12V+ Pink/Black  Ignition Switch Harness or Use Hot Side of Brake
Switched 12V+ Blue  Ignition Switch Harness 
Ground Use Chassis  Near Cruise Control Module 
Hot Side of Brake Red/Black  Back of Fuse Panel. 
Cold Side of Brake White/Tan  Back of Fuse Panel. 
Tach Brown/Green  ECM under Air Cleaner, 1 Cylinder Setting 
VSS Wire White/Orange  Driver's Front Fender 60 Pin Connector Position 58 
Pulses Per Mile 8000 PPM 
Rostra Control Arm 250-3421 
Notes: Vehicles with Manual Transmission require Clutch Switch. Some vehicles may require a speed signal generator and/or other parts/adapters not listed above. Rostra® Cruise Control module switch settings may differ if you use a speed signal generator or magnets and a pick up coil.


  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Tuesday, December 3, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer