viper 5706v remote start issue

I think you've cooked it with those connections.Test before boxing up.

That sucks. Well the only thing I haven't rewired yet would be the H3/4 pink/white wire to the brown yellow. Would I need to switch both accesory wires around or can you have pink/white and orange accessory output to the brown yellow. If that wouldnt matter, I'll just send it out to have it repaired or something.Josh

Not sure but you must program that pink/white as 2nd ACC follow Menu 3 item 8 option2, also menu 3 item 10, option 1 (default). By the way, have you waited 15 seconds, default diesel start delay?Test before boxing up.

Thanks for your help. I'll try these out later.Josh

So I was out poking around with a DMM on some wires on the ignition switch, Checking for 12 volts during crank. The blue/white wire coming out of my ignition switch, cut and connected to the H3/6 Green Starter input wire. Well, while pushing the r/s button, this wire gets no voltage from the switch going into the brain. If i put the key in and turn it to start, this wire gets the full 12v. Any thoughts on that? Josh

It won't the violet on the other side of the cut is the starter OUTPUT from the remote start. The green is the starter INPUT.Test before boxing up.

Does the ignition switch not supply voltage to the green input to the brain. It does when starting with the keyJosh

Why should it? Read my last post again, then look at the instructions.Test before boxing up.