AutoStart won't stay running

I posted here about a month ago with Passlock I problems, and I finally got a chance to fix it. It works great now, especially when it hit -33 C the other night. Thanks for all your help.

But now I have another problem. The r/s was working flawlessly, but now, when it sits for an hour or more, when it remote starts, it will only run for about a minute, shut down, and go through the start cycle again and again until it quits. I checked the start failure codes, and all it gives me is "hardware reset" codes.

It is an AS-1785 installed in a 1996 Pontiac Sunfire, manual trans.

Any help would be much appreciated.

this is indicative of a dead unit.  autostart has been having significant quality control issues lately, so this doesn't surprise me in the least.  I'd bet ya $10 that if you replace the unit with another, it'll work tickety boo.  and yes, the 1996 sunfire would have Passlock I...

b

Hey guys.  Yes, it does have PassLock I, that was what I was having problems with at first. Actually, I had the Starter wire from the bypass module on the OEM starter wire, not on the r/s starter wire which I had moved to the clutch to by pass that. My fault.

Velocity Motors, when I check the start failure codes, it goes 3,4,3,3. The 3 flashes being "hardware reset" and the 4 being brake, when I reset back into ready mode, procedure for manual trans. All the hardware resets, I think, are when I open a door, hood, e-brake, brake, all the safety stuff for a manual trans.

I'm almost positive I have all the wiring where its supposed to be, as it was working properly for a long time, but I thought I had it before too. I haven't done a r/s for a couple of years, so any help I can get is greatly appreciated.

Thank you.