1992 buick remote start, hooking up resistor

anti-grind is not what your problem is-- your problem is "overcranking"  which method did you use "tachless" or "Tach monitoring"?  If tachless- you should try tach monitoring-- the anti-grind feature is so that you don't try to start the car (turn key to "start") when the car is already running.....Brcidd - Engineer That Does Remote Starter Installs on the side.

you need to hook up the WHITE/ red tach wire to a good tach source,If you have a sheet with all the wireing info there should be a tach wire listed.you test the tach wire with a volt meter sey to a/c,the wire should read like 2 to 6 volts and fluctuate with higher rpm.After you find a good tach source and connect your WHITE/ red wire to it you need to use the tach finder mode to make sure the crimestopper unit reconizes this as a good tach source.Once that's done go back into programing and program the unit for tach.

On your car- attach the RED / white tach wire to the white wire coming out of the ignition module- then when you use "tach finder" the parking lites will flash if this is a good tach source-- then if that works- then program option 1 to "Tach Mode" -instead of "Tachless mode"    its that simple-----Brcidd - Engineer That Does Remote Starter Installs on the side.