06 nissan frontier and viper 350hv

sup guys? been a member/lurker here for a long time. this is my first time posting. im about to install the viper 350hv in my 06 nissan frontier. this is my first attempt at car alarm install. i heard it was basic so i decided to try. my question is, how do i disable the factory alarm so that it wont go off when i use the viper? can i just install the viper alarm and leave the factory alarm as it is? chris

	Alarm Disarm		GRAY		(-)		AT BCM MODULE BEHIND DRIVERS SIDE OF DASH ABOVE PEDALS BEHIND DIAGNOSTIC CONNECTOR
	Alarm Arm		LIGHT BLUE		(-)		AT BCM MODULE BEHIND DRIVERS SIDE OF DASH ABOVE PEDALS BEHIND DIAGNOSTIC CONNECTOR

You'll have to disarm the factory alarm, those are the wires you'll be looking for....half of the truth can be worse than a lie. <----Roger Russell said that..

so how do i disarm the factory alarm? do i disconnect the arm/disarmwire? sorry about the noobie question. this is the only thing holding me back right now. thanks.

connect the arm disarm wires and it should disarm upon remote start and unlock

connect the viper arm and disarm right? and disconnect the factory? man, this sounds so simple...sorry guys!!!

i read somewhere that i need to splice a wire and connect it to the ground...do i have to do that?

Take the arm and disarm wires coming off the viper and tap into the arm and disarm wires in the vehicle

sweet! i will do that tomorrow! thanks guys!!!

so i was comparing the diagram from https://www.the12volt.com/installbay/forum_posts.asp~TID~85069 to... viper (listed below) 4-pin shock sensor harness red + constant power input black - chassis ground input blue - multiplex input zone 2 green - multiplex input zone 4 3-pin wire door lock harness green - lock + unlock output empty blue - unlock + lock output 12-pin primary harness orange to starter kill relay white vehicle parking light wire WHITE/ blue programmable output BLACK/ white domelight supervision relay (optional) green to - door wire switch blue optional hood or trunk pin violet to + door switch wire black chassis ground yellow key switch brown siren's red wire red battery RED / white optional accessory can someone kinda point me in the right direction. i want at least the keyless entry and shock sensor working. any help would be appreciated.

which one is the lock and unlock for from the viper? from the 3-pin, it's confusing since it says both unlock and lock for both wires.