2000 s-10 power window conversion

Hi there i have an 2000 s-10 with manual windows that i am converting to power... and my Question is i would like to use the factory switches if possable but to do it do need a new door panel that from an s-10 with factory switches? or is there a plate like the sliverado's that just unscrew? your help would be great thanks!! Vince

i just did a 2000 about a month ago and no there is no plate. you have to use adtermarket switches or replace the door panels. what brand of windows are you using?? drop a line if you need help picking out some switches.Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

i am using spal universal powered window switches

i used switch lit #33040147 and it worked great. go to spal-usa.com and click on power windows. then click on switch kits. it will under the flush mount kits. that will show you what they look like.Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

don't know if the kit # above refers to this kit or not, but the Spal Joker kit has "pods" for the switches, kinda goofy, but still OK. Painted to match they look much better. They can also potentially cover up the hand crank hole. I have done a few S-10's with the Euro trim rings and near flush switches, looks nice and clean. But i used Electric-Life OEM conversion kits. But for top points, i would go for the clean factory look and get a powered S-10 door panels. or cap the hand crank holes and go for a center console switch panel. Viper Equipped