2005 cobalt r/s

Good day to all: I'm going to be doing my first Cobalt (05 MT), and it will be my first one. I want to be as sure as I can. So after reviewing the info on this site, this is what I came up with: 2 Button ProStart 3271 6 PIN MAIN HARNESS: -Red 12v Batt: At BCM J3 Connector pin D1 -Purple 30A Starter Output:N/A -Red 12v Batt: Same as above -Yellow Ign Output:Yellow wire in IGN Harness 5 PIN SECONDARY HARNESS -Black-Ground -Purple (Tach Input):White at Coil -Gray (hood pin): Self explanitory -Orange Brake Switch Input: Light blue driver's kick panel -Yellow Park Light Output:Brown Driver's Kick panel 12 Pin Accessory Harness: The only wires I'm going to use out of here are: Orange Park brake Input: Light Blue Driver's kick panel (BCM J1 Connector pin 14) I believe also I will be needing a passlock 2 bypass. Does everything up above look ok?? Thanks

You came to the right place.  Check out this download from one of the members :  https://www.the12volt.com/installbay/file.asp?ID=717   Everything you ever wanted to know about the Cobalt.Soldering is fun!