91 nissan 240sx and viper 5701

\Well how many parking light flashes does it give you after that error tone? is your car manual or automatic? if manual are you doing the manual trans sequence?[/QUOTE]

PINK (+) IGNITION 1 INPUT/OUTPUT -> Black white

RED / WHITE (30A) FUSED IGNITION 2 / FLEX RELAY INPUT 87 -> white red

ORANGE ACCESSORY OUTPUT -> i dont have hooked up 

VIOLET (+) STARTER OUTPUT -> Car side of BLACK / YELLOW (+)

GREEN (+) STARTER INPUT -> Key side of BLACK / YELLOW(+)

RED (+) FUSED (30A) IGNITION 1 INPUT -> WHITE/ red 

PINK/WHITE (+) IGNITION 2 / FLEX RELAY OUTPUT -> Car side Ignition 2 black yellow 

PINK/BLACK FLEX RELAY INPUT 87A key side (if required) of FLEX RELAY -> i have not hooked up 

RED / BLACK FUSED (30A) ACCESSORY/STARTER INPUT -> WHITE/ red

and on the 90 i dont know if the wiring is different because of the single cam and dual cam motors

but i hooked up the following....

N.S.( BLACK/ white)- ebrake yellow brown or purple it looks like either or

(Brown) to RED / green

and (purple) to GREEN/ black

and i dont have the hood pin hooked up yet cuz i have no use for it yet but let me know what i have wrong

its a manual btw sorry

Sorry for the wait, on the flashes depends how many flashes it gives you, count the flashes and read the manual to determine what is the problem, example 8 flashes would be the hood pin....close the hood. And my car is manual.

(7 flashes Manual transmission mode is enabled and not initialized)

Manual Transmission

If the vehicle has a manual transmission the proper steps must be followed

before leaving the parked vehicle or the remote start feature is

disabled.

1. Make sure the engine is running and the doors on the vehicle are

closed.

2. Put the transmission in neutral.

3. Press on the brake in the vehicle.

4. Apply the emergency brake.

5. Release the brake.

Note: Pressing the brake pedal again after this step will disable the

remote start feature.

6. Within 15 seconds activate the remote start from the remote.

7. The parking lights flash 5-times confirming that the remote start is

active. If the parking lights do not flash 5-times, then repeat steps

1 - 6.

8. Turn off the ignition (the car stays running when key is turned off).

9. exit the vehicle

10. Arm the alarm

(the vehicle should shut off when arming the system).

You can now remote start the vehicle.

(all this info you can find in page 28 of 5901 owner's guide)