mini cooper transponder

I can work out some of them but what are these for? GREEN / WHITE light blue green RED / white black grey/black purple.

http://www.nustart.ca/manuals/5000-Series.pdf page 13 thx

OK, your main loom is correct but the secondary loom...... Green pin 5 goes to the car's PURPLE / black via a relay as so; green to 85 constant 12v+ to 86 and 87, fused at 30amps. 30 to PURPLE / black of car Diode* between pins 85 and 86 band towards 86. The unit is sending a low current neg via the green, thus needs the above relay to change the polarity and boost the current. RED / white pin 8 is split. there are TWO BROWN / grey with yellow dot wires they are at pins 22 and 42 on a black plug at the control unit. Diode* separate with the bands towards the Compustar. You're only picking up one of the doors. You've joined the alarms violet to a BROWN / yellow of the car, why? Have you connected the vehicle locks yet? Is there a comfort close on the Compustar? If so use it, it will close the windows and roof. Also check the voltage on the brake switch, I think it's wrong. *Use 1N4004 diodes

thx a lot

violet to brown yellow for dome-light

Not needed, a) That dome feed is positive, the violet is neg, and it's an aux output not a dome light controller. Not needed, b) The dome lights come on automatically with unlock from the Compustar remote.

my bypass key work now , i can start my car with key . thanks a lot i still work on the remote start. i connect tach wire , brake wire, door pin wire, e-brake wire . i also connect the green wire to the PURPLE / black via a relay. but i haven't connect the clutch wire . i saw two BLACK / YELLOW at driver kick panel at the gray module. can i use harness 3 pin 3 with relay to supply 12v to the BLACK/ yellow clutch wire .