Viper 350, 530t, 2009 Dacia Logan

556U with a spare key for the by-pass, MTM for the transmission.

Today I received the DEI 530t module an I want to install it in the weekend. I talked to a friend about this and he told me that the motors from the windows door are not so powerfull and they could be damaged by this module ?! (Is it true ?). Meaning that when I arm the car and the windows are up, the 530t could force them and in time damage can occur. I think it's not true, 530t could sense that the windows are up and not trigger anymore. And If the windows are down, arm, windows rolling up ..and the motors are forced upon close ? This guy really freak me out. I do not want to burn my windows motors. Does the 530t knows when to stop it when windows are up ?

Thermal cut-outs and timer, no problems. If your friend knows so much, why are you asking here? Yes I do have Romanians coming to me with their cars.

I am asking you to make sure that is no problem and the advices you gave me are from an expert; for this I'm graceful. Thanks

On my ground when armed wire from the alarm I hookup 2 wires : Black wire from my blinking led (Electro-Luminescent Indicator)and orange wire - ground when armed from the DEI 545t Nite-Lite module and here comes another orange wire from the DEI 530t module. Should I connect them all together ? should I use diodes ? In this case how can I connect the diodes ? Thanks

Diodes on all, bands towards the alarm. Do you have a spare aux? Blue/white? Set that to a timed output, 2 secs. longer than it takes to close the windows, say 6-8 seconds, and run that to the 530t. That would therefore act as a safety timer for the 530t. Thus you have a timed cut-out AND the thermal cut-outs, double safety.

I have an spare aux H1/10 WHITE/ BLUE 200 mA (-) channel 3 output - validity output. But how can I set it to a timed output ? In the Viper 5002's manual at Bitwriter Features, It says "Channel 3 Timed 1–90 seconds (30 seconds- factory default)". So I have the Channel 3 timed at 30 seconds ? I think Is not good setting, right ? I do not have Bitwriter to set it proper.

Set it manually via the programming, timed, about 8 seconds, you don't need a bitwriter.

But how can I set it manually ? Using Valet button ? On Menu #3 - Advanced features at the 3-5 position I have Channel 3: Validity (One Chirp Setting) and latched/latched, reset with ignition/30-second/60-second/90-second timed/remote start report (Two chirp setting). How can I set it to 8 seconds timed ?