remote starter crank but not starting

Hi,

 I need your help. I just installed viper 5301 with 1101T bypass module. The car will crank but won’t start. It is like if you start with immobilizer kicking in but i have the key working inside the car. Is there any solution? thx

sorry forgot to say i got infiniti m56 and it has intelligent key

If you leave the functional key fob in the car, will your car start? With the 1101 unplugged. This will tell us if the 1101 is the problem.Sylvain Rochon

MECP security specialist

Tech support for remote starters

26 Years of experience counts

I'm here to help.

No it won't start .. I folloed the install manual which I got from here but for Push 2 start should I follow the manual complitlly or is their any defferance?

What year is your infiniti?Sylvain Rochon

MECP security specialist

Tech support for remote starters

26 Years of experience counts

I'm here to help.

Have you connected the following: Starter     brown (push-button start)(-) Push-button ignition switch or BCM, white 40 pin plug, pin 30 Second Starter     lt. blue (-) BCM, white 40 pin plug, pin 27 And, did you install the relay in the engine compartment for neutral safety switch. It would so much easier if you would have gotten the idata link ADS-AL-CA. Anyhow, you can send me an email directly..check my profile and I can send you pdf files that explains what to do. Sylvain Rochon

MECP security specialist

Tech support for remote starters

26 Years of experience counts

I'm here to help.

It is 2011

hi

today i pushed the PTS button twice to the"on" light

then i remote started the car with the key inside it does remote start

then when i tried to do the same without the key inside the car i wont start

any ideas?

Check your ignition wiring.

hi the Starter   brown (push-button start)(-) is connected to (-) 200mA STARTER OUTPUT i did not connect Second Starter     lt. blue (-) BCM, white 40 pin plug, pin 27 to the remote starter any ideas?