viper 5901 remote start 99 camry

How do I Change the vipers programming to Tach Mode? And it menu 3 paring cause it dosent do anything when I click it And no I didn't do the learn process cause I don't kno how can you walk me through it please?deep bass

By the way I thank you so much for all your help so far!deep bass

A bit late on this but the best place for tach would be the gauges, tach lead or if present, diagnostic socket, pin 9.

If the control module is clicking, are you getting any flashes from the parking lights?  If yes, how many flashes?When all else fails, Read the Instructions

Support the12volt.com Make a Donation

It's clicking 7 times and yes the light are flashing. It wont let me program it tho can someone walk me through the process.deep bass

Im confused on where to connect the Neutral Safety Wire and how do I switch it on and off?? Does the blue status wire need to be connected? Is so to were I dont need a by pass.deep bass

If your car does not need a transponder bypass, use the Vipers' Blue (-) Status Output wire for the Keysense signal :

      Keysense     blue/black  (-)        @ ignition harness

Viper Option Programming

1. Open a door. (The GREEN wire, H1/8, or the VIOLET,H1/6 must be connected.)2. Turn the ignition on, then off. (The heavy gauge PINK wire must be connected.)3. Select a Menu. Press and HOLD the Valet/Program switch. (After 3 seconds the siren will chirp once.  Continue holding the button.  The siren will chirp twice, continue holding the button.) Hold the button until the Siren chirps 3 times, indicating Menu 3.  4. Select a Feature. Press and release the Valet/Program switch the number of times corresponding to the feature you wish to change. For example, to access the third feature, press and release 3 times. Then press the button once more and HOLD it. The siren chirps the number of times equal to the feature you have accessed.  For Transmission Mode, press the button once, then press and hold the button until the siren chirps once.

5. Program the Feature. While holding the Valet/Program switch, you can toggle the feature on and off using the remote control. Pressing the button that arms the system selects the options in increasing order.. Pressing the button that disarms the system selects the options in descending order. Pressing the button that activates the remote start resets the feature to the factory default.  Press the ARM button to select the second option (Auto Trans).

To access another feature in the same menu:

1. Press and release the Valet/Program switch the number of times necessary.  Press Once for Menu 3, Item 2 - Engine Checking.

2. Then press the Valet/Program switch once more and hold it.  Siren chirps twice.3. Press and hold the button and then press the ARM button 3 or 4  times to get to Option 4 - Tach Mode.4. Release the Valet/program switch.

The program routine exits if any of the following occurs:

• The open door is closed• The ignition is turned On• There is no activity for 30 seconds• The Valet/Program switch is pressed too many times

Soldering is fun!

Sorry for the scan of these instructions.  I don't know how to make it into a PDF file.

When all else fails, Read the Instructions

Support the12volt.com Make a Donation

The complete file is in the Downloads/Manuals section. If it isn't I'll upload it to the site.

How can I get my windows to roll up with the remote?deep bass