12 volt constant at ignition gone

Home / the12volt's Install Bay / Vehicle Wiring Information & File Requests / 12 volt constant at ignition gone (

Topic Closed)

Welcome Guest :)

Members

< Prev Page < Prev Topic Next Topic >

oldspark

Gold - Posts: 4,913

Joined: November 03, 2008

Location: Australia

Posted: September 19, 2011 at 8:17 PM / IP Logged

Just a bit if "in general" FYI from my readings & experience:

Removing power for 10 secs or 10 mins (depending on system) is a good way to reset modern devices (EMS etc).

Most EMS then require a few minutes of idling so they can retune. Further retuning may occur over subsequent drive periods.

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

12 volt constant at ignition gone

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.