remote start ignition wiring connection

Did you plug in the Vipers "Neutral Safety Switch"  and set switch to ON?Soldering is fun!

I have actually connected that wire directly to ground instad of connecting the switch inbetween.:d

Ref the horn wire, one word TEST.

Also have you programmed your unit for auto transmission. One phrase,RTFM.

Hi, I have already programmed unit for automatic transmission. Thanks, :d

you have to ground the neutral safety wire AND there is a 2 pin plug with a toggle switch that needs to be plugged into the brain and the switch needs to be ON. its a dual neutral safety and its extremely stupid. that switch cost me an extra 45 minutes on the first one of these i installed because i didnt realize that it actually needs to be plugged into the brain. even professionals have to RTFM sometimes

Excellent, After connecting both neutral safety wires, it worked first time.. Very confusing neutral wire connection description in the manual. Now I run into another problem. I can do system lock/unlock when car is OFF. Once I perform remote start, I cannot unlock my car doors with remote. On the other hand, if doors are unlocked before remote start, I can lock the door with remote. Strange problem.:d

Keysense?

Thank you guys for your help.. Everything worked out properly after soldering down all the wires. I think Viper should upate the installation manual to describe "unusual have to do" steps in it so that installer doesn't hit our head to the wall for such a small point.:d