2007 hummer h2 viper 5704

*in w2w mode

Here is a link to the ADS AL CA flashed with ADS AL(DL) GM1 firmware install guide :

http://www.idatalink.com/support/get-install-guide/guide_id/6614    This is the correctfirmware for your 2007 H2 when using the ADS AL CA module.

Follow the Type 3 install diagram for you 2007 H2.  You will run all the wires shown with

the exception of the Trunk Release, Left and Right Sliding Door wires.  They are not applicable to your vehicle.  Additionally the ADS Door Status Output will only supplythe front doors.  To monitor the rear doors see the info previously supplied.

Soldering is fun!

I've decided to go with the d2d setup. Everything is hookep up. I'm having difficulties programong the viper alarm, idatalink and pairing the 2way remote. 1 way appears to be paired. When i arm and disarm from the 1 way i get a chirp and led on control center flashes consistently. I am unable to put the viper into pairing mode for tge two way. No matter which way i try it wont flash or chirp to say the system is ready for pairing.

I have the right firmware DBI-AL(DL)-GM1(v4.4)

*v4.8

also the idatalink flashes green and when I turn the car over it doesnt flash until the car has finished cracking and started. When I push the remote start button on the one way I can hear the relay clicking but no action otherwise.

doubled checked all connections, everything looks good. First I'm working on how to pair the remote. I can't seem to get the control center to engage pairing mode. Tried power cycling which didn't change anything. Even with the idatalink not hookedup I should still be able to pair the remote with the viper unit?

also let me add that I can still start the truck with the key, with out any problems

Tip. Temporarily ground the green H2/6 wire.

Grounding the h2/6 has lead to some success. I was able to get tge alarm to engage in the programming mode.