pestige aps785 remote start

I checked the manual as suggested. I have found all of the wires and they have been connected. I can not remote start for any reason. There is no indication of an output signal from the yellow start wire to the starter. The manual says that this wire must be connect to the vehicle side of the starter cut relay. Questions: 1. What is the starter cut relay? 2. What would be considered the vehicle side? 3. What would be the opposite of the vehicle side?

1) The relay that cuts the starter, also known as the anti-grind relay. 2) Vehicle side is key side. 3) Starter would be the opposite. To be honest if you have to ask these questions you shouldn't be doing this on your own.

Here's the simple set-up, wiring by follow the colour:- 2BF_95_celica_1.bmp And this one adds the starter cut/anti-grind relay:- copy_of_95_celica_1.bmp

Please note:- If they supplied the relay, complete with base and diode if the band on the diode goes to 85, don't worry, just wire the 85 to ignition 1 and the 86 to Ground when Armed, aka GWR orange wire.

Thanks howie ll for your help. It's gladly appreciated. Thanks for the diagrams as well. I have installed many car radios but never a remote start. I have the alarm, flashers, horn, and everything else just not the remote start. I will go now and try again using the relay with 85 on ignition one and 86 to the orange ground when armed wire. I will let you know the outcome.

Remember to look and see where the diode band is.

Does it matter if the 2pin starter control switch is connected or not?

Just join the leads together.

looking at the diagram with the relay connected it shows both yellow and the other half of the starter wire connected. I twisted all 3 wires together, is that the proper way?

Cut starter wire, key side to 87a. other side + yellow from APS to 30.