2010 silverado idatalink ads aldl gm10

i would like to point out the wires i connected from the alarm h1/1 constant power from fuse box h1/2 to black and white at pk3 pin3 h3/1 to pink at ignition connector at pin 2 h3/3 to brown at pk3 pin 2 just trying to give as much info as possible

AHHHH....   Don't have the install guide for a Python 5706 but if the H3 harness looks like the

one shown below, you will need to connect H3/6 and H3/9 to +12V constant also.  They supplythe +12V to the IGN1 and Accessory & Starter relays.  You can fuse down, etc.

H3/1 PINK (+) IGNITION 1 INPUT/OUTPUT

H3/2 RED / WHITE (87) FLEX RELAY +12V INPUT (30A FUSED)H3/3 ORANGE (+) ACCESSORY OUTPUTH3/4 VIOLET (+) STARTER OUTPUT (CAR SIDE OF THE STARTER KILL)H3/5 GREEN (+) STARTER INPUT (KEY SIDE OF THE STARTER KILL)H3/6 RED IGNITION 1 +12V INPUT (30A FUSED)

H3/7 PINK/WHITE (30) FLEX RELAY OUTPUT (car side of ign, acc or starter wire)H3/8 PINK/BLACK (87a) FLEX RELAY INPUT (key side of ign, acc or starter wire if needed)H3/9 RED / BLACK ACCESSORY/STARTER RELAY +12V INPUT (30A FUSED)

H3/10 NC No Connection

Soldering is fun!

that was it thank you i feel so dumb lol

Don't feel bad, it's a common oversight.   I prefer to attribute it to the poorly written DEI manuals,,,   Soldering is fun!

thanks again sometimes we need a fresh pair of eyes