problem viper 5904 toggle switch off

hello, the switchboard is wrong as to recognize the switch will I have to put - the car chassis. Then my car is a honda civic typer R FN2 2007 and no assembly diagrams civic which is about the same changes. This is my connector: You have blue thread and put in the wiring diagrams http://www.commandocaralarms.com/wiring/2006-2008/honda/civic/945.html connect it as follows: Remote Start, 10-pin heavy gauge connector -H3/1:Pink, (+) Ignition 1 input/output. [Conection ignition harness start button] -H3/2:RED / White, (+) Fused (30A) ignition 2 / Flex relay input 87. [12V white] -H3/3:Orange, (+) Accessory Output. -H3/4:Violet, (+) Starter output (car side of the starter kill). [Cotar cable amarillo parte del coche y conectar] -H3/5:Green, (+) Starter input (key side of the starter kill). [Conectar cable amarillo cortado parte de la llave] -H3/6:Red, (+) Fused (30A)ignition 1 input. [Conectar (+) 12 VDC battery Cable White] -H3/7:Pink/White, (+) Ignition 2/ Flex Relay output. [Conection Cable Red ignition harness] -H3/8:Pink/Black, (+) Flex relay input 87a key side [No Conection] -H3/9:RED / Black, (+) Fused (30A) Accessory/Starter input. [Conection (+) 12 VDC battery Cable White] -H3/10: No connection. with these connections try to boot without turning on the instrument panel and is a long time. Key positions of my car are: Position Accessories: Yellow: this wire is 0V which is bridged to the viper: H3 / 4 Violet and H3 / 5: Green. Red 12 Orange: 0V Position Contact: Yellow: 12V Red 12 Orange: 12V