94 4runner astrostart guidance

Alright I'm out in town. I'll go pick up a 5 prong relay and give it a shot. Any idea on the door locks doing nothing?

When you say verified with test light how did u do it? You should be testing your wires with DMM . The wires from the 4 runner r a (-) you need to put your red test lead to 12v and black lead on youre suspect wire. When you press the lock or unlock you should see 12v. It goes away when you release it.No better feeling then getting a remote start to work right!

So first I stripped the wires so I could test them then I grounded my multi meter and connected the pos to the wire. I hit the button and got a reading but it went so fast that I couldn't see what it was only that it was showing some voltage. So I took my test light and grounded it then connected the other end to the wire. Hit the button and every time I did the test light lit up

Also how do I determine what amp fuse to go with for my 12v on the relay?

I mirrored my fuse off the other protected circuits 25amps. Your the man! She fired right up. Now to dig into the locks

Door locks now work. I tapped into the wires after the relay. My last question is the horn. It does nothing. I'd like to activate the panic feature in it You guys are awesome!

stolher wrote: Absolutely H1 Red and RED / black is on white-constant 12v Orange is on ignition 1 BLACK / YELLOW Yellow is on accessory blue/red Green is on Parking lights green (+) Blue is on black starter wire H2 Brown is on blue/white in kick panel verified with test light that it's the lock Red is nowhere Blue is on blue / YELLOW in kick panel verified with test light that it's the lock (Lock unlock doesn't work) H3 Nothing is installed H6 Green is not connected BLACK/ red hood switch WHITE/ green is on GREEN / WHITE off brake switch Black is grounded BLACK/ green is connected to the diagnostic connector for tach H7 & H8 Nothing H9 Green is connected to GREEN/ red under the column ORANGE / white is not connected Orange is not connected

second ign is the white harness that comes in the box. It it is connected to the pins at the top of the brain, pins 30 and 87. This is a built in relay for the rs system. you will need to cut the harness and connect 1 side to 12 volts and the other to the second ign. as for locks you will need to test to be sure they are the correct wires and then you can trigger them with the appropriate trigger(neg,pos)

Everything is hooked up and works as advertised. Thanks to all who helped. I couldn't have done it without you!

Awsome great job.No better feeling then getting a remote start to work right!