'05 yukon w/ 4204v no start/crank

Home / the12volt's Install Bay / Car Security and Convenience / '05 yukon w/ 4204v no start/crank (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Page < Prev Topic Next Topic >

buddholly

Copper - Posts: 244

Joined: August 24, 2006

Location: United States

Posted: November 22, 2013 at 5:13 PM / IP Logged

Try turning engine checking to off and remote start the vehicle..Sounds like you have a bad unit.

Back to Top

dasbogie

Silver - Posts: 514

Joined: September 30, 2006

Location: Pennsylvania, United States

Posted: November 22, 2013 at 5:29 PM / IP Logged

Are you sure it's not setup for 2 or 3 clicks of the remote start button/activation?

Advanced

Back to Top

smokeman1

Platinum - Posts: 1,588

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: September 14, 2009

Location: Wisconsin, United States

Posted: November 23, 2013 at 9:24 AM / IP Logged

As dasbogie suggested. It is either one or two pulses for the remote. Menu 3, item 5.

If it is the Two Mode, try pressing and holding the start button until the transmit LED flashes twice, release the button and press it again right away and hold until it flashes once, then let go. It is a bit of a timing thing, so give it a few tries. Or enter the menu set up and change it to one pulse. Does the remote give an error tone and red LED at the function button when start attempt fails?

When all else fails, Read the Instructions

Support the12volt.com Make a Donation

Back to Top

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

'05 yukon w/ 4204v no start/crank

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.