viper 5904 will not remote start.

Have you taken it back to whoever install it?When all else fails, Read the Instructions

Support the12volt.com Make a Donation

I'm going to call them in the morning and let them know whats happening so when I take it there they'll have an idea of what to look for. Just started happening last night and they were closed already. It's probably the DBALL2, I think it just doesn't recognize the key for whatever reason. I'll let you know what I find out. I appreciate your help though. thanks jerryj

Leave the key in the ignition, now try it. If it starts it's the by-pass module, if it still doesn't start there's another problem.

I tried that earlier, no luck.

Hey Howie,    Just go back from the installers. The dball2 lost it's memory for some reason. Tech just unplugged it and plugged it back in and programed it again. Simple enough, I thought that might be the problem just from what i've read elsewhere on the net. Good to know if anyone ever has a similar issue.

[QUOTE] Transmitter shutdown (or optional push button).[/QUOTE]

howie ll wrote: Wish I knew what that meant. Not having a joke, I've absolutely no idea what it means.

In DEI-speak, it means a shutdown was received from the fob OR from the wht/blu RS activation wire. Few installations utilize the wht/blu wire, but a (-) pulse on this wire is the same as a RS command from the fob. If the engine is not running, a pulse will start it, and if already running, a pulse will shut it down. DEI-speak takes some patience to master. I'm far from a Master DEI-speak translator, especially on the newer stuff, but the wht/blu wire I know.

Thanks D.

Seem's slower to start now that it's been reprogramed, like about 20 to 30 seconds. It used to start in about 5 seconds, any ideas?

Back to the installers then.

make sure the installer checks the settings on the db-all2! remember the db all is like a little computer........good luck!