viper 5706v won't remote start

https://www.the12volt.com/relays/relaydiagram8.html 86 and 30 to 12 volt source, 85 to H2/18 (-) 200mA Starter output 87 to starter 2 wire of carWhen all else fails, Read the Instructions

Support the12volt.com Make a Donation

I've tried that before but it didn't work. I'm gonna try to check the settings again for tach or flex relay and see. Not sure if those would conflict with it.usn

Here is a video I made up showing basic connections for a remote starter. I used a relay for Accessory 2 in this, but a second starter set up would be similar. All of the outputs are connected to lights to show the 12 volts being applied to each circuit. Maybe it can help. http://youtu.be/uq1ETQxMp7MWhen all else fails, Read the Instructions

Support the12volt.com Make a Donation

I did some more troubleshooting. H2/18 is not clicking the relay. I think it may be bad. Is there a way around it maybe a different output instead.usn

Try using the H2/10 for you 2nd Ignition and change the H3/7 to second Starter.When all else fails, Read the Instructions

Support the12volt.com Make a Donation

Have you put a DMM on the outputs of the H3 harness to see if there is any voltage? Does the remote starter do anything when trying to start? Dash Lights coming on? Trying to start 3 time before stopping? Any flashes from the parking lights to indicate a problem?When all else fails, Read the Instructions

Support the12volt.com Make a Donation

I haven't read the voltage on the harness. When I make h3/7 second starter do I have to change flex relay function to starter 2?usn

That would be a Yes. Menu 3, Item 8, Option 1, Ignition 2, Option 2, Accessory 2, Option 3, Starter 2.When all else fails, Read the Instructions

Support the12volt.com Make a Donation

Do the following:- Your original added relay that didn't work, have you tested it? Inputs and outputs, BTW did you put a quenching diode on the relay? If not you've possibly fried the H2 starter output. Is the aux switch plugged in and on? Black plug. Is the BLACK/ white on H2 either grounded or connected to handbrake switch? Tach learned, connected violet/white on H2 to tach? How have you made your connections?

Aux switch plugged in and on, BLACK/ white is grounded, starter 2 output definitely fried , flex relay function changed to starter 2, I didn't use a diode but I do have some just let me know where to place it,and my car won't learn the tach. I placed that wire on an injector probably should find the tach wire behind the glovebox BLACK/ orange.usn