no heat during remote start

What did you power up at your ignition switch ? IGNITION 1      PURPLE(+)      @ IGNITION SWITCH HARNESS      IGNITION 2      GREEN (+)      @ IGNITION SWITCH HARNESS ACCESSORY /HEATER BLOWER 1      GRAY (+)      @ IGNITION SWITCH HARNESS If i Can't Install it    I Don't need it   Joe

ignition  1 and 2

starter 1 and 2

accessory wire at ignition switch = gray tied into orange input wire on h3 harness for viper remote

jf durf

correction.. gray accessory wire on ignition harnesss was tied into the orange OUTPUT wire in H3 harness for remote.jf durf

Did you connect the Red, RED / White, and RED / Black to a 12 volt source?When all else fails, Read the Instructions

Support the12volt.com Make a Donation

sure did. only wire in H3 harness not connected is the pink/blk flex relay 87a key side. The viper 5301 remote start is working fine. Have a ads-al-ca bypass w2w hooked to it. When car starts the climate control is not actuated, even though it was on when car turned off. If I start car with key the climate control turns on fine. Help!!jf durf

Seems like something isn't getting powered Check your ignition wiring make sure everything is getting powered up. Compare the reading with both the remote start and the key make sure they are getting powered the same way. If i Can't Install it    I Don't need it   Joe

you missed an ignition wire for sure.Ted

2nd Year Tier 1 Medical School

Still installing as a hobby...pays for groceries

Compustar Expert

Yes, what chev said. With the car apart, activate the remote starter. With the remote starter running the engine, test all the ignition wires on the car. When you find an ignition wire that's dead, turn the key on. If it's live now, and the heat works now, that's the wire you have to work on powering up or troubleshooting why it's not getting power.

ok, so I did as instructed and here is what I found. The accessory hookup is correct, gray wire from harness to orange wire from H3 harness to remote. aIt gets power when rs is active. Second, looked at ignition 2 setup. Currently, I have it wired from ignition harness (green wire) to Pink/whtie H3-6 wire( flex relay output +) on RS. When I turn key to ignition it powers the green wire (ign 2), however when I RS the pink/white H3 -6 wire goes from 12v to 0 volts. The h3-8 wire has 12 v before initiating the RS but goes to 0 when I hit the RS button. The H3-7wire pink/blk , is at 12v before and after  RS initiated. Maybe I should switch connection to Pink/Blk wire to ignition 2??? Help? jf durf