How to Create a Ground While armed?

Home / the12volt's Install Bay / Car Security and Convenience / How to Create a Ground While armed?

Welcome Guest :)

Members

< Prev Page < Prev Topic Next Topic >

lurch228

Silver - Posts: 1,338

Joined: August 08, 2012

Posted: September 05, 2016 at 6:13 PM / IP Logged

ADW1212TW Latching Relay for adding a GWA.

How to Create a Ground While armed? - Page 3 -- posted image.

This should be right if not and it works in reverse just swap the lock an unlock wires.

george20000

Member - Posts: 11

Joined: September 03, 2016

Location: Greece

Posted: September 05, 2016 at 6:31 PM / IP Logged

Thank you all for your answers?A last question.how pin have this relay?

Thanks so much

lurch228

Silver - Posts: 1,338

Joined: August 08, 2012

Posted: September 05, 2016 at 6:48 PM / IP Logged

george20000 wrote:

Thank you all for your answers?A last question.how pin have this relay?

Thanks so much

If you are asking how many pins does the relay have it is a 5 pin Relay. The circles are the pins in the diagram.

george20000

Member - Posts: 11

Joined: September 03, 2016

Location: Greece

Posted: September 05, 2016 at 6:55 PM / IP Logged

Thanks for the answers guys.

lurch228

Silver - Posts: 1,338

Joined: August 08, 2012

Posted: September 05, 2016 at 11:53 PM / IP Logged

Your welcome

george20000

Member - Posts: 11

Joined: September 03, 2016

Location: Greece

Posted: September 06, 2016 at 9:30 PM / IP Logged

I need any diode?Because when I lock the doors without alarm I have a standard - ?

lurch228

Silver - Posts: 1,338

Joined: August 08, 2012

Posted: September 07, 2016 at 2:06 AM / IP Logged

If you don't want the locking of doors without alarm to effect the GWA output.

Then yes connect diodes (band side towards vehicle),to vehicle lock and unlock wires, and connect alarm and GWA wires to other side.

george20000

Member - Posts: 11

Joined: September 03, 2016

Location: Greece

Posted: September 07, 2016 at 4:23 AM / IP Logged

OK thanks

lurch228

Silver - Posts: 1,338

Joined: August 08, 2012

Posted: September 07, 2016 at 9:01 AM / IP Logged

Correction the diodes need to be band towards the alarm and GWA relay to block negative from non alarm lock so only alarm can change GWA relay.

Sorry for any confusion.

< Prev Page

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.