Starter over-runs in Tach Mode

I have tried high and low check and the first start after engine sits a few hours over-runs.  Then the second start is OK.  I have set it in learn mode.  Any suggestions ???

1999 Hyundai Accent Auto Page 650 Plus

I will try that.

I suppose I should put the blower and defroster on when I "learn the tach"

Cheers

Travis

Tried turning all accessories on and re-learned the signal.  It still over-runs on the first try AFTER car sits a little.  When I try it again immediately after the over-run it is fine.  Why would it do this ???  I do not want to damage my starter.

hi    

did you get the right talk wire brwn/red or BROWN / yellow at coil. one trick i find works also is to start car set park brake put in gear then lear tach signal. make sur front is clear and get ready to step on brake if park brake doesnt hold when you put it in gear.

thxs kirk

I have tried catching the lowest signal.  I cannot understand why it is selective on when it will overrun.  Usually after car has cooled down.  I will try it under load by brake holds pretty good.

The other problem I have is my AC tester is 500MV and it reads 27.0 to 32.0 is this correct.  I am using the Brown Red at the coil.  Someone suggested the injectors they are really easy to get at.  Should I try them ? 

Thanks for the support guys

Cheers

Travis

Thankyou

I have checked the obvious. The Autopage 650 does accept the programming and I have used the high and low settings but either doesent start at all or starts fine 50% of the time and overruns the other 50& but also created another post regarding what the tach should read I want to make sure it is getting the proper signal.

cheers

Travis