Infinity subwoofers

one last question.... can you connect 1 channel to one coil and the second to the other coil for a stable 2 ohm load at 230 a piece?

This is not recomended due to the differences between amplifier electronics and voice coil irregularities.  Plus, since each coil is 4-ohms, you will operate at the 4-ohm per channel rating, which is the same as 8-ohms total bridged.  If you must use a DVC 4-ohm speaker, and that Kenwood amp, then running bridged into 8-ohms is by far the best setup.  Again, get a SVC 4-ohm speaker for best results with that amp - or get a different amp. Support the12volt.com

I had 2 infinity kappa perfects and i loved them, they were in a sealed custom box i built.. one word clean.. anyways i think there the best subs out there for the money you can get them from ebay or whatever, i loved them until they got stolen...          i heard they didnt sound good really if there ported tho...

I ran two Perfect 12.1s for about 4 years until one of them finally gave up and blew. The last two years of that paralleled on a JBL BP1200.1. So I did what anyone would and bought two more to replace the blown one. Now I have three of them paralleled on the BP1200.1 and love it.

hey DY, he can get a dvc sub for that amp, he can get a dual 2 ohm sub, or a dual 8 ohm sub. 1990 Honda Civic HB:

Clarion DXZ545MP H.U.

2- 6.5" Power Acoustik interiors

Diamond Audio 600.1 amp

Diamond Audio 15" M6MKII

Pyramid PB881X 4 CH. Amp