Basic install stuff and GM questions

Did you just use 2 1N4004 diodes (1 per switch) between the pin switch and the green wire from the alarm?

How did you setup your door locks?

Thanks

The reason I asked if you used 2 diodes is because in this diagram: http://www.directechs.com/techtips/pdfs/resources/security/directed_techtips/1073.pdf 

they used 4. I dont really know if the 2 diodes seperating the BCM from the switches are necessary.

I think I may have found my solution to my door locks.

http://www.directechs.com/techtips/pdfs/resources/security/directed_techtips/1041.pdf

On page 20 it looks like that diagram would work. In my mind the top relay is used just to change the polarity of the 2nd unlock pulse and since it is in between the switch and the factory relays it would unlock all the doors. The bottom relay is used because you tap into the drivers motor after the factory relays and the brain output cant power the motor so you use a relay. To me this makes sense, is this the way it is done? Anyone know the color of the wires or if I have to go inside the door to get between the relays and the motor?

I used 2 n4001 diodes, 1 coming off each door pin wire, and ran these to the green alarm trigger wire. Make sure you face the diode in the proper direction.  See here.....https://www.the12volt.com/carsecurity/page5.asp

I dont have power locks, so not sure on that one.

Hope this helps...

-Rich