2002 Monte Carlo Alarm/Remote Start Wiring

MONTE CARLO       2000-2004        WIRE COLORS LOCATION 12 VOLTS CONSTANT RED (2) IGNITION SWITCH HARNESS See NOTE * IGNITION 1 PINK (+) IGNITION SWITCH HARNESS See NOTE * IGNITION 2 DARK GREEN (+) IGNITION SWITCH HARNESS See NOTE * ACCESSORY /HEATER BLOWER 1 ORANGE (+) IGNITION SWITCH HARNESS See NOTE * ACCESSORY /HEATER BLOWER 2 BROWN (+) NOTE ** IGNITION SWITCH HARNESS See NOTE * STARTER YELLOW (+) IGNITION SWITCH HARNESS See NOTE * PARKING LIGHTS WHITE ( - ) in PINK 24 pin PLUG, Pin A2 at the BCM *SEE DIAGRAM* See NOTE *** DOME LIGHT BLUE/WHITE (-) and BLUE ( - ) GRAY 16 pin PLUG, Pin A8 and A1 at the BCM See NOTE **** POWER DOOR LOCK ORANGE / BLACK (480 ohm Resistor) GRAY 24 Pin PLUG, Pin B3 at the BCM, (TYPE "B") POWER DOOR UNLOCK ORANGE / BLACK (Same wire) *SEE DIAGRAM*    See NOTE ***** TRUNK RELEASE BLACK ( - ) at the TRUNK RELEASE SWITCH TACH SENSOR WHITE (AC) at the IGNITION COIL BRAKE WHITE(+) at the SWITCH ABOVE the BRAKE PEDAL HORN BLACK ( - ) at the STEERING COLUMN HARNESS               See NOTE ****** FACTORY DISARM LIGHT GREEN ( - ) GRAY 16 Pin PLUG, Pin B3 at the BCM FACTORY ANTI-THEFT GM's PASSLOCK II Requires part # 791 bypass module NOTE *    The ignition harness is located far to the right of the steering column, behind the ignition switch. NOTE **   This wire must be powered as an accessory wire. If powered as a 2nd ignition the car will not crank. NOTE ***    The BCM (Body Control Module) is located above the brake pedal. It is a plastic box with three plugs that face the firewall. You must diode isolate this wire from the BCM when doing remote start to avoid the service engine soon light. NOTE ****    The driver door trigger is BLUE (-). The BLUE/WHITE (-) will catch the passenger door. Use both wires and diode isolate both. NOTE *****      Lock requires a (-) Negative trigger thru a 480 ohm resistor. Unlock requires a straight (-) Negative trigger. Must use relays if the unit does not have on-board relays built in. NOTE ******   Horn can also be found at a BLACK plug with a BLUE insert above the gas pedal.                                                         

DIRECTWIRE™ WIRING INFORMATION - CHEVROLET / MONTE CARLO / 2002 / Remote Start

12volts red    +   ignition harness

Notes: The ignition harness is located far right of the steering column, behind the ignition switch.

Starter yellow    +   ignition harness

Notes: The ignition harness is located far right of the steering column, behind the ignition switch.

Second Starter          

Ignition pink    +   ignition harness

Notes: The ignition harness is located far right of the steering column, behind the ignition switch.

Second Ignition green    +   ignition harness

Notes: The ignition harness is located far right of the steering column, behind the ignition switch.

Third Ignition          

Accessory orange    +   ignition harness

Notes: The ignition harness is located far right of the steering column, behind the ignition switch.

Second Accessory brown    +   ignition harness

Notes: This wire must be powered as an accessory wire. If powered as an 2nd ignition the car will not crank.

The ignition harness is located far right of the steering column, behind the ignition switch.

Keysense          

Power Lock ORANGE / black   -   gray 24-pin plug @ BCM

Notes: Lock and unlock use the same wire. Lock requires a negative trigger with a 470 ohm resistor in-line. Unlock is negative trigger. Must use relays.

The BCM is located above the brake pedal. It is a plastic box with three plugs that face the firewall.

Power Unlock same wire as lock       

Lock Motor          

Notes: Installation of factory keyless upgrade alarm is not recommended on this vehicle because the door lock motor wires rest at approximately 7 volts.

Unlock Motor          

Notes: Installation of factory keyless upgrade alarm is not recommended on this vehicle because the door lock motor wires rest at approximately 7 volts.

Parking Lights+ do NOT use       

Parking Lights- white      pink 24-pin plug @ BCM

Notes: Must isolate this wire from the BCM to avoid service engine soon light. See DirectFax document 1600 for wiring information.

The BCM is located above the brake pedal. It is a plastic box with three plugs that face the firewall.

Hazards          

Turn Signal(L)          

Turn Signal(R)          

Reverse Light          

Door Trigger      -   gray 16-pin plug @ BCM

Notes: The drivers door trigger wire is blue. Blue/white will catch the passenger door. Use both wires and diode isolate each.

The BCM is located above the brake pedal. It is a plastic box with three plugs that face the firewall.

Have to also diode isolate from the BCM to prevent false alarms. Refer to DirectFax document 1076 for wiring information.

Dome Supervision use door trigger       

Trunk/Hatch Pin RED / black    -   gray 24-pin plug @ BCM

Notes: The BCM is located above the brake pedal. It is a plastic box with three plugs that face the firewall.

Have to also diode isolate from the BCM to prevent false alarms. Refer to DirectFax document 1076 for wiring information.

Hood Pin          

Trunk/Hatch Release black    -   release switch

Power Sliding Door          

Factory Alarm Arm          

Factory Alarm Disarm lt green    -   gray 16-pin plug @ BCM

Notes: The BCM is located above the brake pedal. It is a plastic box with three plugs that face the firewall.

Disarm No Unlock          

Tachometer white      ignition coil

Wait to start          

Brake Wire white    +   brake switch

Parking Brake          

Horn Trigger black    -   steering column

Notes: Horn can also be found at the black plug with a blue insert above the gas pedal.

Memory Seat 1          

Memory Seat 2          

Memory Seat 3          

Immobilizer Bypass Module: Required: Yes Type: Passlock 2 Part #: 555L or 555T

Notes: N/A

      

This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.

Chevrolet Monte Carlo 2000-2003 Remote Starter Wiring Colors and Notes Function    Vehicle Color Location Start:    Yellow (+) Ignition switch harness** Ignition #1:    Pink (+) Ignition switch harness* Ignition #2:    Dk.Green (+) Ignition switch harness** Ignition #3:    N/A Accessory:    Orange (+) Ignition switch harness** Brake Light:    White (+) Brake pedal switch Tach Signal:    White (AC) Ignition coil Parking Lights:    White (-) Pink # pin plug at BCM*** Headlights:     OEM Alarm Disarm:    Lt.Green (-) Gray # pin plug @ BCM*** OEM Alarm Arm:     Diesel Glow Plug:    N/A Clutch Bypass Wire:     Notes:    * This Vehicle Is Equipped With GM's Passlock II Anti-Theft System. Use Universal Alarm Bypass Module part # 2x402 where X can be any number. **The ignition harness is located on the far right side of the steering column, behind the ignition switch. ***The BCM (Body Control Module) is located above the brake pedal. Is is a plastic box with three plugs that face the firewall. -------------------------------------------------------------------------------- Chevrolet Monte Carlo 2000-2003 Alarm and Keyless Entry Wiring Colors and Notes Function    Vehicle Color Location Constant +12 Volts:    Red (+) Ignition switch harness Starter Kill:    Yellow (+) Ignition switch harness** Ignition +12 Volts:    Pink (+) Ignition switch harness* Dome Lights/Superv:    Green Ignition switch harness OEM Horn:    Black (-) Steering column harness Power Lock:    ORANGE / Black (-) Gray # pin plug at BCM**** Power Unlock:    ORANGE / Black (-) Gray # pin plug at BCM**** Trunk Release:    Black (-) Release switch Alarm Input Wire:    Green Ignition switch harness Notes: ****See Installation Note #211. Single Wire Door Lock System. A Negative (-) Ground Pulse Through A 470 Ohm Resistor Will Lock The Doors. A Negative (-) Ground Pulse Will Unlock The Doors.

Make:   Chevrolet Model: Monte Carlo Year:    2000-02 This Database Was Last Updated On:    9/16/2004 Index #: 1878 Alarm Constant 12 volts RED IGNITION SWITCH HARNESS Ignition 12 volts PINK IGNITION SWITCH HARNESS Starter YELLOW IGNITION SWITCH HARNESS Dome Light D BLUE/WHITE (-) BCM IN DRIVER KICK PANEL Trunk Pin Switch RED / BLACK (-) AT LIGHT IN TRUNK OR BCM Parking Lamp BROWN / WHITE (+) AT JUNCTION BLOCK IN PASSENGER KICK Power Lock ORANGE / BLACK (-) ** AT BCM ON DRIVER SIDE Power Unlock SINGLE WIRE SYSTEM OF INST PANEL #217 *The Drivers Door Trigger Wire Is BLUE. BLUE/WHITE Will Catch The Passenger Door. ** ORANGE / BLACK Door Lock Wire Must Receive A Ground (-) Pulse Thru A 470 Ohm Resistor To Lock And A Solid Ground (-) Pulse To Unlock. #217- See Single Wire Resistor Door Lock Diagram. View Diagrams Accessories Window Up D\ D BLUE P\ L BLUE @ MAIN #211 Window Down R/ BROWN S/ TAN SWITCH Ign Key Warn L GREEN (-) STEERING COLUMN HARNESS OR BCM Trunk Release BLACK AT TRUNK RELEASE SWITCH #230 OEM Horn BLACK (-) STEERING COLUMN HARNESS OR BCM Headlights YELLOW (-) AT HEADLIGHT SWITCH OR BCM OEM Alarm Arm N/A OEM Alarm Disarm LT GREEN (-) AT BCM ON DRIVER SIDE INST PANEL * * Located In Pin #4 Of A 16 Pin Harness. #211 - See Reversal Rest At Ground Power Window Circuit Diagram. #230 - See Negative Pulse Trunk Release Diagram. View Diagrams Remote Start Tach Signal WHITE AT IGNITION CONTROL MODULE * #238 Ignition #2 DARK GREEN IGNITION SWITCH HARNESS Ignition #3 ORANGE IGNITION SWITCH HARNESS (HVAC) Accessory BROWN IGNITION SWITCH HARNESS Neutral Safety NOT GROUNDING TYPE - OEM SWITCH OPENS STARTER CIRCUIT Brake Light WHITE (+) AT SWITCH ABOVE BRAKE PEDAL Reverse Light L GREEN (+) AT LIGHTS Rear Window Defrost N/A TIMER BUILT INTO SWITCH * Ignition Control Module Is Located On Top Of Engine. #238 - See GM PassLock II Diagram Note : The Engine Will Not Turn Over Until The PassLock Is Connected View Diagrams