Help with my Clifford RSX 3.5

Im looking for the remote start wiring schematics...

These are the colors for the heavy gauge wires for ignition, starter etc.

1. PURPLE-starter side of starter wire

2. GREEN-key side of starter wire

3. RED-12volt constant input

4. ORANGE-accessory output

5. PINK/WHITE-2nd ignition output

6. RED / WHITE-12volt constant input

7. PINK-ignition output

I have this same system but I am looking for directions on how to make connections for door locks using the 451 door lock module that came in the box  there were no schematics for the locks maybe you can help me on that part thanks.

actually i dont know but i can find out from some friends... ill get back to you as soon as i talk to them

actually i dont know but i can find out from some friends... ill get back to you as soon as i talk to them. Thanks again i really appreciate your help!

what kind of car is it going into? i do know how to wire it for negative  because that is how mine is set up.

if you have negative locks this is how it goes

PURPLE - grounded

BLUE and GREEN - neg to locks

WHITE/ BLACK and BROWN / BLACK - pos (not used)

if you have negative door locks this is how it is wired:

PURPLE - grounded

GREEN and BLUE - neg to door locks

BROWN and WHITE - pos to door locks (not used)

Hi my locks are positive pulse,  anyways was the info I gave you ok? I will find what I need for my installation but if your friends can help I would appreciate it. Thanks.

well there are two types of positive pulse locks, type A and type C (type B is negative). What type of vehicle is it? i can tell you how to wire both of them but i need to know which type you have because if you have type C and you wire it for type A you can damage your 451. and also do you have a 451 or a 451M because you may need extra relays depending on what type of locks you have.