the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

need wiring for 05' Maxima


Post ReplyPost New Topic
< Prev Topic Next Topic >
kauaikainoa 
Member - Posts: 2
Member spacespace
Joined: October 27, 2004
Location: Hawaii, United States
Posted: April 26, 2005 at 5:29 PM / IP Logged  
wassup! anybody have the wiring schemz for the new 05' Maxima? I'm gonna do a Clifford with remote start w/ window modules... THANX!
byron dizon
thepencil 
Gold - Posts: 1,526
Gold spacespace
Joined: December 16, 2002
Location: Canada
Posted: April 26, 2005 at 6:00 PM / IP Logged  
DIRECTWIRE™ WIRING INFORMATION - NISSAN / MAXIMA / 2005 / Remote Start
12volts green (40A)   +   ignition harness
Starter BLACK/ red   +   ignition harness
Second Starter BLACK / YELLOW   +   ignition harness
Ignition BLACK/ red   +   ignition harness
Second Ignition N/A       
Third Ignition N/A       
Accessory red   +   ignition harness
Second Accessory WHITE/ blue   +   ignition harness
Keysense BLACK/ red   +   ignition harness or BCM, pin 37
Notes: The BCM (Body Control Module) is between the steering column and the fuse box.
Power Lock blue or pink/blue   -   driver door module in door
Notes: Meter this wire while turning the key in the driver door key cylinder.
Power Unlock red (double pulse)   -   driver door module in door
Notes: Meter this wire while turning the key in the driver door key cylinder.
Lock Motor gray   5wi BCM, pin 50
Notes: The BCM (Body Control Module) is between the steering column and the fuse box.
Unlock Motor green   5wi BCM, pin 44
Notes: The BCM (Body Control Module) is between the steering column and the fuse box.
Parking Lights+ RED / blue   +   driver kick, harness to rear
Parking Lights- N/A       
Hazards GREEN/ red   -   BCM, pin 29
Notes: The BCM (Body Control Module) is between the steering column and the fuse box.
Turn Signal(L) GREEN/ black   +   BCM, pin 45
Notes: The BCM (Body Control Module) is between the steering column and the fuse box.
Turn Signal(R) GREEN/ YELLOW   +   BCM, pin 46
Notes: The BCM (Body Control Module) is between the steering column and the fuse box.
Reverse Light GREEN / WHITE   +   driver kick, harness to rear
Door Trigger see notes   -   BCM
Notes: The LF door is lt. blue in pin 62, the RF door is BROWN / white in pin 12, the LR door is RED / black in pin 63, and the RR door is blue/red in pin 13. Use all four wires and diode isolate each.
The BCM (Body Control Module) is between the steering column and the fuse box.
Dome Supervision red   -   BCM, pin 48
Notes: The BCM (Body Control Module) is between the steering column and the fuse box.
Trunk/Hatch Pin PURPLE / white   -   BCM, pin 57
Notes: The BCM (Body Control Module) is between the steering column and the fuse box.
Hood Pin N/A       
Trunk/Hatch Release blue or blue/white   -   BCM, pin 30
Notes: The BCM (Body Control Module) is between the steering column and the fuse box.
The fuel door release is green in the driver kick, in the harness to the rear. It is a high current negative wire.
Power Sliding Door N/A       
Factory Alarm Arm arms with lock       
Factory Alarm Disarm disarms with unlock       
Disarm No Unlock single pulse power unlock wire       
Tachometer NOT red or black   ac   any ignition coil or fuel injector
Wait to start N/A       
Brake Wire RED / green   +   brake pedal switch
Parking Brake pink/black   -   parking brake switch
Horn Trigger GREEN / WHITE   -   horn switch
Memory Seat 1 blue/white   -   ADP Control Unit, pin 9
Notes: The ADP (Automatic Drive Positioner) control unit is the second module below the display in the dash.
Memory Seat 2 purple   -   ADP Control Unit, pin 25
Notes: The ADP (Automatic Drive Positioner) control unit is the second module below the display in the dash.
Memory Seat 3 N/A   -     
Immobilizer Bypass Module: Required: Yes Type: Transponder Part #: 556U or 555U
Notes: Standard on all models.
      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
Be careful whose advice you buy, but be patient with those who supply it.need wiring for 05' Maxima -- posted image.
KarTuneMan 
Platinum - Posts: 7,056
Platinum spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member consistently provides reliable informationspace
Joined: December 14, 2004
Location: Isle Of Man
Posted: April 26, 2005 at 6:12 PM / IP Logged  

you dont need the window modules.....

Send a 1 min pulse to the unlock....the 2 front windows go down

send the 1 min. pulse to the  lock, and they go up....

metaverse 
Copper - Posts: 210
Copper spacespace
Joined: June 13, 2002
Location: United States
Posted: April 27, 2005 at 8:32 PM / IP Logged  
Is that right ? A 60-second pulse ? Interesting info..not questioning..just verifying for future use..
KarTuneMan 
Platinum - Posts: 7,056
Platinum spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member consistently provides reliable informationspace
Joined: December 14, 2004
Location: Isle Of Man
Posted: April 27, 2005 at 9:29 PM / IP Logged  
Beins I'm an astroflex dealer...Im lucky...All of there units have 4 programable outputs, all of wich can be prgrammed for any start features (start,acc,ign...etc.)     pulse times are 7/10 of a second 1 min, and 8 min. dome light, pulse before start, pulse after start.....and a whole lot more..KooL. Flexible
kauaikainoa 
Member - Posts: 2
Member spacespace
Joined: October 27, 2004
Location: Hawaii, United States
Posted: April 30, 2005 at 4:40 PM / IP Logged  
hey everbody! Thanx sooo much for the info...... i just wanted to know just one more thing.. for the 05'  Maxima, non- bose, is there ne thing special about changing out the head unit.  I just got the mounting kit and harnesses.  I was just wondering if anything needed to be bypassed, or something like that
byron dizon

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Saturday, April 27, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer