Viper 791XV
DIRECTWIRE™ WIRING INFORMATION - HYUNDAI / SANTA FE / 2001 / Remote Start
12volts red and blue + ignition harness
Starter lt. GREEN/ black + ignition harness
Second Starter N/A
Ignition pink + ignition harness
Second Ignition pink + ignition harness
Third Ignition N/A
Accessory blue + ignition harness
Second Accessory N/A
Keysense brown + ignition harness
Power Lock yellow - driver kick, white 22 pin plug
Power Unlock WHITE/ black - driver kick, white 22 pin plug
Lock Motor gray 5wi driver kick, white 22 pin plug
Unlock Motor white 5wi driver kick, white 22 pin plug
Parking Lights+ GREEN/ orange + fuse box, 15 pin plug
Parking Lights- lt. blue/blue - headlight switch
Hazards green (only w/fac. alarm) - ETACS, 12 pin plug
Notes: The ETACS module is attached to the back of the fusebox on the bottom.
Turn Signal(L) pink + steering column
Turn Signal(R) gray + steering column
Reverse Light RED / black + fuse box, top right plug
Door Trigger yellow - fuse box, 8 pin plug
Dome Supervision use door trigger
Trunk/Hatch Pin BLACK/ orange - fuse box, 15 pin plug
Hood Pin pink - ETACS, 12 pin plug
Notes: The ETACS module is attached to the back of the fusebox on the bottom.
The hood pin is also green at the switch under the hood.
Trunk/Hatch Release N/A
Power Sliding Door N/A
Factory Alarm Arm factory remote only
Factory Alarm Disarm factory remote only
Disarm No Unlock disarms with remote start
Tachometer WHITE/ black or blue ac ECM
Notes: The ECM (Engine Control Module) is under the center console to the right of the gas pedal. On the 2.4L with A/T it is in the 26 pin plug, the 2.4L with M/T it is in the 12 pin plug, and the 2.7L it is in the 40 pin plug.
Wait to start N/A
Brake Wire GREEN/ black + brake pedal switch
Parking Brake GREEN/ black - parking brake switch
Horn Trigger brown - steering column
Memory Seat 1 N/A
Memory Seat 2 N/A
Memory Seat 3 N/A
Immobilizer Bypass Module: Required: No Type: N/A Part #: N/A
Notes: N/A
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
Be careful whose advice you buy, but be patient with those who supply it.