Factory Sub

Home / the12volt's Install Bay / Car Audio / Factory Sub (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

cnschweg

Member - Posts: 1

Joined: July 25, 2005

Location: United States

Posted: July 25, 2005 at 11:36 AM / IP Logged

I was told I could use the factory inputs to the factory sub amp on an aftermarket amp, as long as I put rca ends on them. I'd run a new power lead, but would like to use the factory signal wires if possible. does anyone know which wires these are? Thanks

Craig---

Back to Top

JAydawg21

Copper - Posts: 51

Joined: July 01, 2005

Location: United States

Posted: July 25, 2005 at 12:14 PM / IP Logged

well, if your using the wires that acctually connect to the sub itself, you either need to buy an amp that has a high voltage input, or buy a live converter to step down the signal. The signal that appears across the acctuall speaker terminals has already been amplified and is too large for standard rca inputs which are typically around 4 - 5 volts

'97 Jeep Cherokee sport

subs: JL 12w3v2 : RF 500a2 :

RF 1F capacitor

doors: 6" Diamond D361i -> RF 200a4

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Factory Sub

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.