2001 mercury cougar remote starter

power to both 12v wires, power on the accessory line, and a 12v surge to both the ignition and starter when remote started

mistahiggs wrote: power to both 12v wires, power on the accessory line, and a 12v surge to both the ignition and starter when remote started

Surge to the ignition? The Ignition should show power and remain on throughout the whole sequence. Is it really surging like the starter wire or is it constant during the remote start cycle?Steve G

yes doulbe check to see if got constant vlots on the igntion wire, if it is surge, check the other igntion wire in the realy pack, in the case its a bad relay use the another igntion wire on the relay pack. when you are checkign the voltage are you doing on wires in the relay pack or the igntion harness. waht kind of connection are you using. if they are T-taps, or other liek that remove them and re do it, with out the T-taps.

I'll have to double check the voltage again tomorrow on the ignition, and I am checking the voltages next to the ignition harness. I never use t-taps, only eyelets, wraps and solder. Hopefully it's just a bad realy. Thanks for all the feedback.

well if you did not use Taps and have a good connection dotn matter were you take volts at. just narrow it down to something.