91 mazda 626 m/t remote install

trying to install prostart ct-3360 in 91 mazda 626 with manual trany both wiring diagrams ive found at 12 volt .com and prostart show different wiring ..can get to tach learn and exit car in ready mode with car running as it is supposed to do and can turn off with transmitter but will not start .all controls will flash park lights except the start button ..it will not signal the remote at all .has any one got a good wiring diagram on this veh  with manual trany

                                                                                                           thanks ...V.Ford

thanks for the ideas linked up both wires at the clutch switch sill will not respond with transmitter ..i still can exit the veh in ready  mode will shut off will start button but still will not start  ..should the park lights flash when i go to start the car..it seems ok with trunk,lock and unlock ...this is a canadian 626 mazda and i would feel alot warmer if i was 100 % sure of proper wiring  at the inigition switch .. as i said have two different wiring diagrams one even shows a secondary ingition.. for the same year..duhhh  and the best is the wiring coulors just dont match  up

where else can i  get a proper wiring diagram

                                                   thanks ..Vince Ford